Search for dissertations about: "DISSERTATION ON finite element analysis of mechanical component"
Showing result 1 - 5 of 6 swedish dissertations containing the words DISSERTATION ON finite element analysis of mechanical component.
-
1. Microstructure-based Mechanical Behaviour in Structural Analyses of Cast Components
Abstract : In the process of developing cast iron and cast aluminium components, the co-operation between product development and production is important. On the engineering level, this co-operation is limited already in the product development phase e.g. by the lack of established methods to consider the mechanical behaviour of the completed component. READ MORE
-
2. Simulation of Microstructure-based Mechanical Behaviour of Cast Components
Abstract : In the process of developing cast iron and cast aluminium components, a high level of co-operation between product development and production is of great importance. From an engineering standpoint, this co-operation is limited early in the product development phase by e.g. READ MORE
-
3. On the deformation behavior and cracking of ductile iron; effect of microstructure
Abstract : This thesis focuses on the effect of microstructural variation on the mechanical properties and deformation behavior of ductile iron. To research and determine these effects, two grades of ductile iron, (i) GJS-500-7 and (ii) high silicon GJS-500-14, were cast in a geometry containing several plates with different section thicknesses in order to produce microstructural variation. READ MORE
-
4. Dynamic characteristics of automobile exhaust system components
Abstract : Demands on emission control, and low vibration and noise levels have made the design of automobile exhaust systems a much more complex task over the last few decades. This, combined with increasing competition in the automobile industry, has rendered physical prototype testing impractical as the main support for design decisions. READ MORE
-
5. Numerical investigation on the formation mechanism of residual stress in metal cutting
Abstract : Residual stress can be introduced unintentionally into the workpiece with various magnitudes and distributions through all manufacturing processes. These stresses have a significant effect upon the performance of the final component. READ MORE