Search for dissertations about: "Tool steel"

Showing result 16 - 20 of 157 swedish dissertations containing the words Tool steel.

  1. 16. Effect of austenitising temperature and cooling rate on microstructures of hot-work tool steels

    University dissertation from Trollhättan : University West

    Author : María Teresa Coll Ferrari; Högskolan Väst.; [2015]
    Keywords : TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; Tool steel; Heat Treatment; Austenitising Temperature; Large Tools; Tempering Carbides; Bainitic Microstructures; Production Technology; Produktionsteknik;

    Abstract : The average size of hot-work tools has gradually increased over the past years.This affects the effective temperature cycle tools experience during hardening,as large dimensions prevent uniform and rapid cooling, and thereby the resulting microstructures and properties. READ MORE

  2. 17. Critical Aspects of High Performance Manufacturing of Structural Sintered Steel

    University dissertation from Trollhättan : University West

    Author : Sepehr Hatami; [2008]
    Keywords : TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; Tool Steels; Modelling; Controlled Atmosphere; Wear Mechanisms; Sintering; Pressing Dies; Chromium Alloyed Steel;

    Abstract : Steel is the dominant material for the production of structural parts. By means of powder metallurgy (PM) processing, manufacturers have been able to manufacture steel parts with appreciable dimensional accuracy and proper mechanical properties. READ MORE

  3. 18. White Layer Formation during Hard Turning of Through-Hardened Martensitic and Bainitic AISI 52100 Steel

    University dissertation from Trollhättan : University West

    Author : Seyed Hosseini; [2015]
    Keywords : TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; white layers; residual stresses; phase transformation; dynamic recovery; bainite; dynamic recrystallization; carbide deformation; retained austenite; steel; martensite;

    Abstract : Increased demands for flexible manufacturing lines, shorter cycle times and reduced impact on the environment drives the need for optimization of today’s manufacturing. For machining of hardened steel parts (>45 HRC), grinding has been the obvious choice for many decades. However, hard turning has often been considered as a replacement due to e. READ MORE

  4. 19. On wear of wood-cutting tools : Tool materials, wear mechanisms and modelling

    University dissertation from Karlstad : Karlstad University Studies

    Author : Johan Nordström; [2005]
    Keywords : Tool material; Wood cutting; Wear; Modelling;

    Abstract : Bandsaw blades are commonly used in the sawmill industry for timber cutting. The saw teeth are gradually worn during cutting and will finally cause unacceptable surface roughness and dimensional deviations on the sawn wood product. Maintenance by re-sharpening of the saw teeth is therefore necessary after a certain time of sawing. READ MORE

  5. 20. Fracture behaviour and related microstructures of tool steels parted-off at high rates of strain

    University dissertation from Karlstad : Karlstad University Studies

    Author : Kristina Ryttberg; [2007]
    Keywords : TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; high-velocity parting-off; adiabatic cutting; high strain-rate deformation; TEM; steel; adiabatic shear band;

    Abstract : Increasing steel prices and environmental aspects have put forward the demand to reduce material consumption in manufacturing industry and near-net-shape manufacturing techniques have thus become increasingly important. High-velocity parting-off, or adiabatic cutting, has shown to result in very low material waste as well as narrow dimensional tolerances of parted-off samples. READ MORE