Search for dissertations about: "quenching steel"
Showing result 1 - 5 of 32 swedish dissertations containing the words quenching steel.
-
1. Hardening of Carbon Steel by Water Impinging Jet Quenching Technique : Differential Cooling of Steel Sheets and Quenching of Cylindrical Bars
Abstract : Austenitization followed by quenching is a well-known conventional heat-treating procedure which is widely used on carbon steels with the aim to obtain high strength in as-quenched condition. Such quenching is usually done by immersing a steel product into the cooling medium which provides a uniform cooling of the surface. READ MORE
-
2. Toughness of Tool Steel
Abstract : Toughness is the ability to resist tensile stresses in the presence of a notch or crack. Sometimes gross cracking of industrial tools, mould or dies, occurs due to insufficient toughness. As the economic consequences of the gross cracking are serious, the toughness of industrial tool material, generally tool steel, is of paramount importance. READ MORE
-
3. Fatigue Anisotropy in Forged Components
Abstract : Ever-growing requirements on combustion engine efficiency of motor vehicles demand increasing service loads in powertrain components. Optimization of component material is therefore inevitable. A major detriment with many forged transmission components is their anisotropic mechanical behavior, not least during cyclic loading. READ MORE
-
4. Increasing phase transformation rate in advanced high strength steel applications
Abstract : The bainite transformation rate has been shown to increase by starting the heat treatment with partial martensite transformation after austenitization. Based on this fact, a process very similar to “Quenching and Partitioning” (Q&P) is used to produce a fine-grained complex microstructure of martensite, bainite and retained austenite with outstanding mechanical properties in a very short time. READ MORE
-
5. Formation and Chemical Development of Non-metallic Inclusions in Ladle Treatment of Steel
Abstract : The present study was carried out to investigate theformation and chemical development of non-metallic inclusionsduring ladle treatment of steel.To begin with, an investigation of the deoxidation processand the impact of aluminium addition was carried out. For thispurpose, a new experimental setup was constructed. READ MORE