Detection of myocardial ischemia clinical and experimental studies with focus on vectorcardiography, heart rate and perioperative conditions

Abstract: Introduction. Multiple clinical methods for detecting myocardial ischemia are utilised in the hospital setting each day, but there is uncertainty about their diagnostic accuracy. In the operating room, multiple methods may be employed, while in the CCU advanced electrophysiological (ECG) techniques for myocardial ischemia detection, and in particular, ST segment analysis, are common. Vectorcardiography (VCG) is one form of ECG.Several conditions other than ischemia may cause marked ST changes, which can impair the process of diagnosis of clinical ischemia. Elevated HR is one of these factors, which is studied here. The hypotheses were about concordance of different methods to detect ischemia, and relation of ECG ST levels to HR with and without myocardial ischemia.Methods. Study I. Anesthetised vascular surgical patients with coronary artery disease were studied during the start of anesthesia and surgery: ECG, hemodynamic, mechanical, and metabolic parameters were measured and categorised as positive or negative with reference to a specific definition of myocardial ischemia. Study II. Awake patients with no ischemic heart disease were paced in graded steps, and VCG ST analyses were performed.Study III. Anesthetised pigs were studied for local metabolic and VCG ST changes related to controlled HR levels and transient coronary occlusion. Study IV. Thirty five anesthetised coronary artery disease (CAD) patients and ten non-CAD patients were paced at controlled levels, and great coronary artery vein (GCV) lactate measurement was used to determine presence or absence of myocardial ischemia. The CAD patients were paced up to HR levels where myocardial ischemia could be confirmed. The relation of HR-related VCG ST levels to presence or absence of ischemia was analysed. In Studies II,, III, and IV the ST vector magnitude (ST-VM), the change from baseline in ST-VM (STC-VM), and the vector angle change from baseline (STC-VA) were analysed for each step.Results. Study I. Poor concordance was demonstrated for positive events (presumed myocardial ischemia) between the hemodynamic, ECG, mechanical, and metabolic detection methods. Study II. STC-VM but not ST-VM levels demonstrated HR-related increases in the presumed absence of myocardial ischemia in 18 awake subjects. J point time to ST measurement did not affect the response of VCG ST to HR. Study III. STC-VM levels showed HR-related increases in the absence of ischemia (tested by local metabolic observations). VCG ST parameters responded positively to transient regional ischemia. Study IV. CAD patients, which demonstrated a clear pattern of onset and progress of ischemia during pacing, were further analysed for the relation of VCG ST level to ischemia. Sensitivity and specificity of STC-VM levels were described by ROC analysis for a range of STC-VM levels.Conclusions. Concordance of different measures for detection of onset of myocardial ischemia is difficult to assess in the absence of a very reliable reference method. The contribution of HR and ischemia to VCG ST levels were estimated in study subjects. HR-related increases in STC-VM occur in the absence of ischemia. HR levels need to be considered when interpreting STC-VM as a diagnostic test for ischemia. Further study is needed to establish criteria that take into account multiple clinical factors in order to improve the predictive value of our tests for myocardial ischemia.