Structure and morphology control of organic semiconductors for functional optoelectronic applications

Abstract: The functionality and application of organic semiconductors are largely dependent on their constituent structure and morphology. This thesis presents a number of functional and novel approaches for the control and tuning of structural and morphological features of a variety of organic semiconductor materials, and also demonstrates that these approaches can be utilized for improved device operation of field-effect transistors, organic solar cells and light-emitting electrochemical cells.The fullerene family is a particular group of closed-cage organic semiconductors, which can be photochemically coupled into larger dimeric or polymeric structures through the excitation of the fullerene molecules by light emission. In Paper I, we perform a detailed experimental and analytical investigation, which demonstrates that this photochemical monomer-to-dimer transformation requires that both constituent fullerene molecules are photoexcited. The direct consequence is that the initial probability for the photochemical transformation is dependent on the square of the light-emission intensity.The photochemical coupling of fullerene molecules commonly results in a distinctly lowered solubility in common hydrophobic solvents, which can be utilized for the direct patterning of fullerene films by resist-free lithography. In Paper II, we utilize this patterning opportunity for the fabrication of one-dimensional fullerene nano-stripes using two-beam laser interference lithography. A desired high contrast between the patterned and non-patterned fullerene regions is facilitated by the non-linear response of the photochemical transformation process, as predicted by the findings in Paper I. The patterned fullerene nano-stripes were utilized as the active material in field-effect transistors, which featured high electron mobility and large on-off ratio.This patterning was in Paper III extended into easy tunable two-dimensional fullerene structures by the design and development of an exposure setup, essentially comprising a laser and a spatial light modulator featuring >8 millions of independently controlled mirrors. With this approach, we could fabricate well-defined fullerene microdots over a several square-millimeter sized area, which was utilized as an internal out-coupling layer in a light-emitting electrochemical cell with significantly enhanced light output.Paper IV reports on the development of a new “spray-sintering” method for the cost-efficient solution-based deposition of the active material in light-emitting electrochemical cells. This carefully designed approach effectively resolves the issue with phase separation between the hydrophobic organic semiconductor and the hydrophilic electrolyte that results in a sub-par LEC performance, and also allows for the direct fabrication of LEC devices onto complex surfaces, including a stainless-steel fork.Paper V finally reports on the design and synthesis of a soluble small molecule, featuring a donor-acceptor-donor configuration. It acts as the donor when combined with a soluble fullerene acceptor in the active material of organic solar cells, and such devices with optimized donor/acceptor nanomorphology feature a high open-circuit voltage of ~1.0 V during solar illumination.