Fibre Bragg Gratings Characterization, Realization and Simulation

Abstract: The main topic of this thesis is realization and characterization of fibre Bragg gratings.A novel versatile grating fabrication technique is developed and a number of gratings are realized, showing the potential of the system. Arbitrarily-shaped gratings are sequentially imprinted in the fibre by a moving interference pattern created with a continuous-wave ultraviolet (UV) source. This scheme allows for a very good control and stability of the grating shape, which is also shown experimentally. As opposed to most other present fabrication techniques, the proposed method offers a total control over the grating parameters by software, enabling simple implementation of new designs.Different kinds of error sources when stitching long gratings are identified and investigated regarding impact on the final grating result.Another important question within this field is how to characterize gratings. We propose a new characterization method based on optical low-coherence reflectometry (OLCR). A new interferometer design allows for simple simultaneous detection of the reflection response from two different points in the interrogated grating, so that differential measurements can be performed. The advantage of this is that the sensitivity to noise caused by e.g. thermal fluctuations in the system is substantially reduced. Several test gratings have been investigated and a very good agreement to the expected results is noted.A second characterization technique using interferometric detection of the side diffraction from the grating under test is investigated both theoretically and experimentally. With aid of two-dimensional theory for wave propagation, it is shown that there is a linear relation between the detected phase and modulation depth and the corresponding grating properties. The technique is evaluated with a novel scheme of implementation where the UV source provided in a fabrication setup is used assource for the side probe. This approach results in a very simple implementation and opens for an integration of the characterization and fabrication systems.Finally, a tuning method for transmission filters based on local heating of linearly chirped fibre Bragg gratings is analysed and further developed to allow for fully software-controlled operation. The potential of this technique is illustrated by some promising initial experimental results.